BXM76900 Nanobeast

The Beastx NANOBEAST is a control unit for smallest RC model helicopters with no flybar. The integrated gyroscopic elements stabilize the helicopter as much as possible so that it follows only the control commands of the pilot.
The steering feel can be adjusted from tame to extremely agile. Thus, the model meets almost all requirements of pilots, no matter if beginner or 3D professional.
As the Microbeast system, through a firmware upgrade, the system can be extended to "ProEdition" (subject to a charge).
This offers additional functions such as the AttitudeControl for position stabilization and rescue of the model in unsafe attitude, as well as a bank switching which allows to switch between different parameter sets in flight.
To set and tune the Nanobeast system, you need a computer (Windows / mac) or a smartphone or tablet (iOS / Android) with Bluetooth LE. Depending on the technology you need then either a USB2SYS (for computer) or BLE2SYS (for Smartphone / Tablet) interface.
This is not included and must be purchased separately. The configuration then takes place via the StudioX software, which is offered for free download.

Supported receiver types / transmission protocols:
• SRXL: JR XBus (Mode B), Multiplex SRXL (V1 + V2), Jeti UDI, Graupner / SJ HOTT SUMD, Spektrum SRXL
• Futaba SBUS
• Single satellite (Spektrum DSM2 / DSMX, JR RJ-01 DMSS)
• Jeti EXBUS
• ALIGN / FlySky iBus
• PPM sum signal (SPPM)

Specifications:

Input voltage: 4.8V to 6.0V
Recommended helicopter size: 180 - 250 electric
Dimensions: 32x20x10mm
Weight: 5.8g

In the box:
• NANOBEAST control unit
• Patch cable for composite signal receiver
• adhesive pad
• User manual