"T" for Telemetry

Supported telemetry-protocols:

- Graupner HoTT V4

- Jeti ExBUS

- Multiplex Sensor BUS V2

- MSH Brain 2

- Spirit FBL

- Mikado Vbar Control

- YGE-protocol for different telemetry-connections for example via YGE TexY (Futaba, Spektrum, FrSky)

All usual informations as current, voltage, capacity, RPM, temperature etc. will be transferred to your transmitter. The amount of data and the characterisation depends on your transmitter/receiver.

Technical Specifications:

- The specified current is the maximum continuous full power current

- 4 to 14s LiPo, incl under voltage protection by power reduction

- 5 to 16s LiFePo4, incl under voltage protection by power reduction

- BEC 5,0V – 8,4V

- BEC 12A continuous, 30A Peak

- Current limiting

- pluggable receiver- and telemetry cables with JST-socket

- Disconnectable under voltage detection

- Electronic speed control (Governor- mode)

- Soft start

- Active free-wheel, allowing unlimited part load operation.

- Automatic or 6 step adjustable timing

- Frequency: Automatic.

- Adjustable EMK brake

- F3A(Acro brake (brake force control infinitely adjustable)

- Speed limit: 240.000 rpm (2- Poles)

- Temperature and overload warning

- Anti- flash: decreases the closing spark.

- Basic -Programming with mode programming

- Fine adjustment and selection of telemetry log with the PC Setup

- Suitable USB-adapter optionally available

- Dimensions in mm: ca. 84 x 56 x 31

- Weight without / with wires: ca. 219g / 287g

- Cable diameter battery / motor: 6² / 6²

suitable for all about 650