Goblin Kraken 700S

Kraken 700 S - The evolution never ends

The Kraken 700 goes into the second round. The evergreen from SAB now comes with a lighter main gear from the RAW series. In addition, completely new 700S CFRP main rotor blades were developed, which further improve the flight characteristics in every respect and increase efficiency. These innovations are rounded off by new carbon trim parts with fresh paintwork and large areas of visible carbon.

Goblin Kraken 700S Top Features

• Encapsulated main gear of the 2nd generation - extremely quiet - extremely durable - extremely light
• modular design - extremely easy to maintain
• Main rotor shaft made from a new special steel alloy with flanged freewheel
• Gear stage for rear belt drive derived from the main gearbox
• New ultra-light rotor head made of 7075 aluminum
• Rotor head damping freely selectable
• new tail gear - 22% lighter than previous Goblin 700 versions
• new rear and hood design with integrated frame structure
• new rear attachment with quick attachment
• the entire concept is extremely robust, maintenance-friendly and crash-resistant
• Newly developed main and tail rotor blades of the 700S series for higher efficiency  

Compact & Quiet

The closed main gear of the 
2nd generation from the RAW series 
is another revolutionary 
milestone. Extremely resilient 
, it ensures smooth running and 
gives the entire mechanical 
structure even greater rigidity. 

Easy

to maintain The main shaft can be removed after removing 
just a single screw 

Optimum space allocation

The optimized space concept offers space for 
an orderly and clear installation 
of all components. In addition, short 
cable routes are realized for the motor and controller.

Technical specifications

• Rotor diameter: 1600mm (with 700mm rotor blades)
• Maximum usable blade length: 730mm
• Tail rotor diameter: 284mm (with 105mm tail blades) 
  Maximum length of the tail blades used 115mm
• Weight: approx. 3820g ready to fly but without drive 
  battery Weight airframe: 2700g (with rotor blades without drive & electronics)
• Recommended drive battery: 12S LiPo with 4,200mAh to 6,000mAh
• Required TS servos: 40mm 
  Required tail servo: 40mm
• Possible gear ratios: 11.8:1 to 8.4:1 
  Reduction included in the kit: 21z - 10.1:1
• Rear ratio: 4.9:1 
• Recommended motor/ESC setup: 4525/4530 series motor 480KV to 560KV / ESC approx. 130A to 200A
• Maximum motor dimensions: diameter 62mm / height 70mm
• Battery bay: 56mm x 60mm x 320mm
• Recommended battery 12S (2x 6S) with 1400g to 1700g

- First gear stage via toothed belt 
- Second gear stage closed in aluminum housing

- HPS-2 rotor system 
- made of super light aluminum alloy

- Main gear stage made from few parts 
- Extremely robust, compact and light

- Controller holder directly in front of the engine 
- ensures good cooling and short cable lengths

- Battery rail inserted upside down 
- enables battery change in seconds

- Standard cable duct 
- err. very simple and accurate cable routing

The Goblin Kraken Kit includes

Heli kit with pre-painted CF body parts 
21z pulley for motor 
SAB 700S blades 
SAB 105mm tail blades Needed 

separately: 
motor, controller, battery, RC system with FBL system and servos